Characterization and mitigation of nitrous oxide (N2O) emissions from partial and full-nitrification BNR processes based on post-anoxic aeration control

It has been reported that a directional change from anoxic to aerobic conditions is a common trigger for nitrous oxide (N2O) production by ammonia oxidizing bacteria (AOB). By extension, during anoxic-aerobic cycling, post-anoxic dissolved oxygen (DO) concentrations might likely play a role in the magnitude of N2O emissions observed. The overall goal of this study was to determine the impact of three select post-anoxic DO concentrations (0.8, 2.0 and 3.0 mg O2/l) on N2O emissions from partial nitrification (PN) and full-nitrification (FN) reactors subjected to anoxic-aerobic cycling and, ultimately, to explore the development of strategies to minimize N2O emissions from PN and FN based biological nitrogen removal (BNR) processes. Statistically similar N2O emission was observed during anoxia for both the PN (0.62 ± 0.21% N load) and FN (0.61 ± 0.070% N load) processes. In contrast, N2O emissions were statistically lower for PN (0.86 ± 0.25% N load) than for FN (4.6 ± 2.8% N load), during the post-anoxic aerobic phase, when compared together for all three post-anoxic DO concentrations. Further, for PN, the highest N2O emissions were observed at the highest post-anoxic DO concentration of 3.0 mg O2/L (1.2% N load), likely due to the highest corresponding AOB specific growth rate. In contrast, for FN, the highest N2O emissions were at the lowest post-anoxic DO concentration of 0.8 mg O2/L (8.5% N load). The higher emissions from FN process at low DO concentrations were associated with a lag in nitrite oxidizing bacteria activity upon recovery to aerobic conditions. This lag phase contributed to transient nitrite accumulation, and in turn correlated positively to observed N2O emissions. Based on our findings, a gradual ramp up in post-anoxic DO concentrations can minimize N2O emissions during PN based BNR, whereas a completely different strategy, entailing a rapid increase in post-anoxic DO concentrations can minimize emissions during FN based BNR operations. This article is protected by copyright. All rights reserved.

Informació addicional

  • Any: 2015
  • Autors: Ariane Coelho Brotto, Huosheng Li, Muriel Dumit, Jordi Gabarro, Jesús Colprim, Sudhir Murthy and Kartik Chandran
  • Referència: Biotechnology and Bioengineering, 112: 2241–2247

Cercar articles




Laboratori d’Enginyeria Química i Ambiental

Institut de Medi Ambient
Universitat de Girona
Campus Montilivi
17003 Girona

Parc Científic i Tecnològic de la UdG
Edifici Jaume Casademont, Porta B
Pic de Peguera, 15
17003 Girona
Tel. +34 972 41 98 59



Xarxes socials

Segueix-nos a ...

Facebook Twitter Youtube Linkedin

NOTE! This site uses cookies and similar technologies. If you not change browser settings, you agree to it. Cookie Policy